Bando TL1210 1/2 TL BORE 1/2 (.500) C-Frame

Bando TL1210 1/2 TL BORE 1/2 (.500) C-FrameBando TL1210 1 2 TL bushings are preferred where mounting space is at a premium. The TL bushing can only be installed in the conventional (large end outboard) position.

AllTempDD-034

342 LI² Rated Load Load Point 1 2 3 4 5 6 7 Armature Amps 0

2x(Code P) No load current 6

0 a Front Face Code Standard Front Shaft Indicator None Heater Indicator No Heater Insulation Class F Inverter Code Inverter Ready KVA Code H Lifting Lugs Standard Lifting Lugs Locked Bearing Indicator Locked Bearing Motor Lead Exit Ko Box Motor Lead Termination Flying Leads Motor Lead Quantity/Wire Size 9 @ 8 AWG Motor Type 1254M Mounting Arrangement F1 Number of Poles 4 Overall Length 30

0 a Front Face Code Standard Front Shaft Indicator None Heater Indicator No Heater Insulation Class F Inverter Code Not Inverter IP Rating NONE KVA Code G Lifting Lugs Standard Lifting Lugs Locked Bearing Indicator No Locked Bearing Motor Lead Exit Ko Box Motor Lead Termination Flying Leads Motor Lead Quantity/Wire Size 12 @ 10 AWG Motor Type 4052M Mounting Arrangement F1 Number of Poles 4 Overall Length 23

lb Locked rotor torque 130 % Breakdown torque 229 % Locked rotor time 10s (cold) 6s (hot) Moment of inertia (J) 0

75J035W062H2 HP 2 VOLTS 230/460 AMP 5

5 a Front Face Code Drip Cover Mounting Front Shaft Indicator None Heater Indicator No Heater Insulation Class B Inverter Code Not Inverter KVA Code H Lifting Lugs No Lifting Lugs Locked Bearing Indicator Locked Bearing Motor Lead Exit Terminal Panel Or Lead Hole Motor Lead Termination Flying Leads Motor Lead Quantity/Wire Size 4 @ 16 AWG

Standard NEMA MG-1 Frequency 60 Hz Voltage 460 V Number of poles 2 Degree of Protection IP23 Synchronous speed 3600 rpm Output rating 350 HP Mounting F-1 Flange Special Terminal box¹ Left position Enclosure IC01 - ODP

33 % Rated voltage 380 V Rated current 142 A L

EMVM3611C SPEC

9 LB-FT Locked-Rotor Torque 77