Polaris XP1000 Flag / Whip Mount X Tapp Torque Tool

Polaris XP1000 Flag / Whip Mount X Tapp Torque ToolThese angled flag mounts attach to the rear angled portion of the OEM Polaris cage on the 2 and 4 seat XP 1000s. They have a 1 2 hole drilled in them to accept most whips. 1. 75 Clamp size required on the Xp1000s SOLD EACH ADDITIONAL INFORMATION WEIGHT 0. 44 lbs DIMENSIONS 6 4 2 in FINISH Black E Coat, Silver Anodized

but have their own primary clutch setup

then set the leg height off the roof tabs and weld it all together

or up to 1 inch above or below the center line of the lights by pivoting these mounts up or down

Double sheer gusset plates are available

Polaris OEM Head Gasket

Radius Rod Double Sheer Plate - 4130 flat plate (0

- Ran on 2017 BITD Class 10 Championship winning car

2016+ Yamaha YXZ

The durable and reliable performance of this wheel is sure to satisfy the needs of any off-road enthusiast

(1) AlphaBud mono earbud for the driver

Big Power (500+HP) X3’s can have an issue with the lower case clearances opening up after a few runs

Talk to passengers