Phaetus PS Hardened Steel Nozzle V2 0.4/1.75mm (with DLC Coating) (DLC-HS-PS-NOZZLE-V2-0400) B07FJW6H4L

Phaetus PS Hardened Steel Nozzle V2 0.4/1.75mm (with DLC Coating) (DLC-HS-PS-NOZZLE-V2-0400) B07FJW6H4LBrand: PHAETUS Features: DLC coating on whole nozzle surface with its hardness HV2200, thickness 2m, and friction coefficient 0. 05; Fine finish, low adhesion, high wear resistance. Superior quality imported high speed steel bars, special post treatment, high temperature hardness up to HRC62. Overall high temperature resistance 450, suitable for PEEK and other special engineering plastics printing. Min. hole diameter 0. 2mm (0. 01mm) to meet special

and upgrade for ultra-high-temperature printing

75mm Threaded V6 heatsink

PartNumber: RC-NOZZLE-HTX-AS-0250-SPK

easy to use GPS smart antenna receiver

Please note: Whilst these Hotends are rated to 320°C this only applies to the X1E printer

and the "older" nozzles from the HAKKO FR-810

this means there is no need to adjust your pre-existing mount and fan duct setups

1 x 4 pins Fan 5V/12V/24V Selection Drop-in Installation Careful header spacing and location means that wiring will be a breeze

No adjustments to the device are required

Anti-reverse connection protection on the power interface prevents users from burning the motherboard when mistakenly connecting the reverse power line during DIY

It contains everything needed to support the microcontroller

Compact also means rigid