SparkFun Weather Shield Breakout Boards

SparkFun Weather Shield Breakout BoardsThe SparkFun Weather Shield is an easy to use Arduino shield that grants you access to barometric pressure, relative humidity, luminosity and temperature. There are also connections on this shield to optional sensors such as wind speed, direction, rain gauge and GPS for location and super accurate timing. The Weather Shield utilizes the Si7021 humidity temperature sensor, the MPL3115A2 barometric pressure sensor and the ALS PT19 light sensor. The

The HiFiBerry DAC+ Pro is a high-resolution digital-to-analog for the Raspberry Pi (newer models with 40 pin GPIO connector)

automatic on/off or triggered 12V input modes allow easy integration into automated systems

It is fast

A Full Uninterrupted / Uninterruptible Power Supply (UPS) solution

not the Digi+ or the Amp+

It's our take on an 'all-in-one' Arduino-compatible + Bluetooth Low Energy with built in USB and battery charging

Because it's part of our Feather eco-system

Conventional subwoofers are traditionally considered optimized when you can feel rather than hear the bass

The LEDs are controlled by shift-registers that are chained up down the strip so you can shorten or lengthen the strip

This is a Lithium Ion and Lithium Polymer battery charger

no backlight is required

The OLED uses only the two I2C pins on the Feather