Flat Race 1 1/2 Bore Bearing eddy

Flat Race 1 1/2 Bore Bearing eddyThis is an 1 1 2 bore bearing with a flat outer race. It goes in many different Clipper seed cleaner models. It is used in the barrel casting that has the adjusting nut attached to it.

It measures 1 1/8” from the base to the center of the shaft going through it

This shaft diameter is ¾” dimeter

It bolts to the frame of the cleaner and has a hole for the auger clean-out door handle to go through

5-13/16" x 1-1/4" x 1/8" (qty 2)

but it DOES NOT include the brushes

8 total pulley assemblies are used on both the Eliminator 224 & Clipper M-2B seed cleaners with screen cleaning brush systems

This is an 1 15/16 bore top fan bearing for Clipper seed cleaners

They are installed on the rotating shaft and on the stationary side wall of the Debearder

This H-Frame brush carrier holds the brushes under the screens and rides back and forth on the brush carrier shafts to keep the screens clean

Clipper M-2B Auger Assembly

It usually goes on the bottom blast fan on several Clipper cleaner models

mounting rails