Jeep TJ/LJ Cage Dash Tie In 97-06 Wrangler TJ/TJ Unlimited Motobilt Bearing OD_3.265"

Jeep TJ/LJ Cage Dash Tie In 97-06 Wrangler TJ/TJ Unlimited Motobilt Bearing OD_3.265"The Motobilt Jeep TJ LJ Cage Dash Tie In Mount is a clean and simple way to tie in the front section of a cage. The mounts are CAD designed and formed to fit tight to the dash allowing the door to close and maximize leg room. They are CNC cut and formed on a hydraulic press brake from 3 16 inch steel plate. They are designed to fit tight to the dash and extend to the floor. The vertical section at the time was built with strength in mind. A dash bar

12 Inside Diameter (In): 1

130" overall assembly length

181" snap ring distance (outside of cap to outside of cap)

7/16"-20 ring gear bolt threads

Dana 44 front axle with 5x5

Colby Valve Ultimate Valve System 2-Pack

Bearing Type:

(1) outer pinion bearing (Timken M802048)

What makes these brackets unique is there mounting width at the axle tube has been necked down to fit on the small amount of axle tube available

(1) reluctor ring

Dana 60 / Dana 61 / Dana 70 rear axles (outer bearing)

Dana Spicer 10031870