Dual Idler Assembly Blower Parts

Dual Idler Assembly Blower PartsThis Dual Idler Assembly is designed to reduce the oscillation of the belt on the tension side allowing improved contact wrap with the drive pulley. This is a particular advantage on dragsters using a small 32 tooth top pulley. The system also incorporates quality high speed bearings in (2) crowned pulleys** for improved belt life well over 11,000 RPM **Pulleys are 3. 400" wide (86. 4mm) and are designed to be used with an 84mm wide belt. We also

Belts are sold individually

Ignition data acquisition accepts multiple runs

without Front Bearing Support

Noonan & Total Flow Chrysler hemi cylinder heads

650” to 3

and to check for clearance between the end of the bolt & your gear drive

Adjusting Screw 5/16" Ball 7/16-20 Thread W/ Pressure Feed Side Hole H13 Tool Steel

16 X 5/16" ball adjusting screw

Now there is even more control with the PN 7761 module for the Power Grid System Controller

When the pickup is triggered

The lightweight assembly is injection molded for great durability and produces an intense strobe that is easy to view even in daylight

These light weight reinforced 75 tooth 8mm bottom pulleys are designed specifically for supercharged Hemi's using a RCD Center Flange Gear drive and a 84mm (3