Rob Cosman's Dovetail Marking Knife: 019 Kerf Workshop

Rob Cosman's Dovetail Marking Knife: 019 Kerf WorkshopIn 2013 I perfected a process taught by Ernest Joyce for transferring your tail board cuts onto the pin board, resulting in a perfectly placed starter kerf. Without removing the waste, Ernest would place his dovetail saw in the tail board cuts and mark onto the top of the pin board. It was cumbersome and uncomfortable to hold onto the saw by its teeth, and also increased the risk of misaligning the two boards. I decided to develop a saw tooth blade

Each of our Card Scraper Tools are made from torrefied wood

The reference face is approximately 1-3/4 inch (45mm) in diameter

You drill a dog hole to align with your workbench's dog hole strip

just keep checking back

The biggest issue with most tape measures is that little hook on the end

File grades are classified as bastard cut

triple tempered

but the Shawn Shim helps improve your offset accuracy

NO RETURNS ON FACTORY SECONDS

The pictures on this page are representative of the typical flaws that make a saw a second

allowing for uniform surface contact between the sandpaper and wood while you sand

Planing: What the different bench planes are used for